Soleus Air FS40RA Manual and User Guide download pdf (Page 4)

This product employs overload protection (fuse). A blown fuse indicates an overload or

short-circuit situation. If the fuse blows, unplug the product from the outlet. Replace the

fuse per the instructions below and check the product. If the replacement fuse blows, a

short-circuit may be present and the product should be discarded or returned to an

authorized service facility for examination and/or repair.

HOW TO REPLACE THE FUSE

1. Unplug the fan from the outlet. Place the plug on a firm, flat

surface. Open the fuse cover, located on the top of the

plug, using your thumb or a flathead screwdriver to slide

the over towards the prongs.

NOTE: Ensure that the fuse cover is completely open

before attempting to remove the fuse.

2. Remove the fuse carefully by using a small screwdriver to

pry the fuse out of the compartment by the metal ends of

the fuse.

3. Risk of fire. Insert a new 5 Amp, 125 Volt fuse into the fuse

compartment, making sure that the fuse is securely in

place.

4. Slide the fuse cover closed completely. If the fuse cover is

difficult to close, make sure the fuse is properly secured in

place by pressing down on the metal ends of the fuse.

CAUTION: Risk of fire. Do not replace the attachment plug. It

contains a safety device (fuse) that should not be removed. Do

not use the product if the attachment plug is damaged.

To avoid a risk of fire, only replace with a 5 Amp, 125 Volt fuse.

To order a new fuse, contact Soleus Air at: (888) 876-5387

1 2 3 4 5 6 7 8 9

No comments

Soleus Air FS40RA Manual and User Guide Page 4